FALCON
Electronic brushless motor
Micromotor 40.000 – 50.000 – 60.000 rpm delivering superb torque performance at all speeds. Features include sealed high quality bearings. So as to function impeccably on all materials and even in dusty environments.
- Ergonomic design adapted particularly for small hands.
- Due to the efficiency of the motor a study has shown that there is an approximate 20% saving in bur use.
- Excellent price-quality ratio.
- This unit runs very quietly even after extensive use – 3,000 hours.
- The motor is rated for 5,000+ hours.
- Increased capacity with reduced consumption at high performance: does not disperse energy/does not pollute.
- Maximum Ncm power: 7.8 Ncm.
- Hand piece measures: length 160 mm / ø 27 mm
- Weight 210 g. (excluding the lead)
- The handpiece is made from a plastic that will not cause allergies
- Handpiece grip ø 19 mm
This unit is suitable for various uses:
- dental laboratory
- industry
- art decoration
- jewelry
- nail art
- electronics board.
Equipment
- Support for Handpiece
- Set of tools for chuck maintenance
Technical features
- Handpiece weight: 210 g (power cable excluded)
- Feed power: 230V – 50/60 Hz (110 V on request)
- Handpiece measures: length 160 mm / ø 27 mm
Versions
- K 40P: with pedal control. 2 different speed ranges
– Speed 1.000-30.000/40.000 rpm
– Torque 7,8 N.cm
– Total weight 3,500 g - K 40T: with fully digital bench control with reverse facility and on-off foot switch
– Speed 1,000-40,000 rpm
– Torque 7,8 N.cm
– Total weight 4,000 g - K 40TV: with fully digital bench control with reverse facility and variable foot switch
– Speed 1,000-40,000 rpm
– Torque 7,8 N.cm
– Total weight 4,300 g - K 50TV: with fully digital bench control with reverse facility and variable foot switch.
– Speed 1,000-50,000 rpm
– Torque 7,0 N.cm
– Total weight 4,300 g - K 60TV: with fully digital bench control with reverse facility and variable foot switch.
– Speed 1,000-50,000 rpm
– Boost 60.000 rpm in 30 sec.
– Torque 6,5 N.cm
– Total weight 4,300 gCautions
Please keep the bur diameter and the RPM according to this diagram to prevent accidents.
N.B. Insert the bur till the bottom.Bur ø RPM < 2 mm 50.000/60.000 2-4 mm 40.000 4-8 mm 30.000 8-18 mm 20.000 18-28 mm 15.000 28-40 mm 10.000 > 40 mm 5.000